Manage cookies
Cookie Settings
Cookies necessary for the correct operation of the site are always enabled.
Other cookies are configurable.
Other cookies are configurable.
Request Product Information
Interested in learning more about this product or need a custom solution? Please fill out the form below, and our team will get back to you promptly.
T46 Press-In terminals for 0.042” diameter holes
Wire-Wrap terminal single and double-tailed (accessible from both sides)
0.025” square posts
Provides secure contact without soldering or staking
Rectangular base with stepped shank presses into plain or plated-thru holes and is retained without etching or soldering
Pointed ends slide neatly into all wrapping bits
260 Cartridge Brass
Request Product Information
Interested in learning more about this product or need a custom solution? Please fill out the form below, and our team will get back to you promptly.
T44, T68 Bifurcated miniwrap terminals for 0.042” diameter holes
Wire-Wrap tail with two-pronged receptacle for wires or leads
0.025” square posts
Rectangular terminal with stepped shank presses securely into plated or unplated holes, requires no staking or soldering
Bifurcated end holds soldered leads securely
T44: maximum 0.021” diameter leads or 24 gage wires
T68: maximum 0.032” diameter leads or 20 gage wires
260 Cartridge Brass
Request Product Information
Interested in learning more about this product or need a custom solution? Please fill out the form below, and our team will get back to you promptly.
T49 Trifurcated Klipwrap terminals for 0.042" diameter holes
Wire-Wrap tail with two-pronged receptacle for wires or leads
0.025” square posts
Wires or leads are crimped into receptacle on component side, secured for soldering
Holds 0.018” - 0.025” diameter leads or 22 gage wires in lower slot, 0.032” - 0.040” diameter leads or 17 gage wires in upper slot
Overall length - 0.650”, 0.215” above 0.062” thick board with 0.373” below the board
Phosphor Bronze
Request Product Information
Interested in learning more about this product or need a custom solution? Please fill out the form below, and our team will get back to you promptly.
TT125, T126 Wire Wrap Terminals for 0.042” diameter holes
Pressfit wire-wrap terminals, ideal for connecting voltage and ground holes in Vectorbord plus™ and Pads & Planes™ patterns
2-level terminals: Part No. T125
3-level terminals: Part No. T126
Phosphor Bronze
Request Product Information
Interested in learning more about this product or need a custom solution? Please fill out the form below, and our team will get back to you promptly.
