​■  Pressfit wire-wrap terminals, ideal for connecting voltage and ground holes in
     Vectorbord plus™ and Pads & Planes™ patterns
​■  2-level terminals: Part No. T125
​■  3-level terminals: Part No. T126
​■  Phosphor Bronze

T49

Tools sold separately

Wire-Wrap Terminals

T46-2, -3, -5

​■  Wire-Wrap tail with two-pronged receptacle for wires or leads
■  0.025” square posts
■  Rectangular terminal with stepped shank presses securely into plated or    

     unplated holes, requires no staking or soldering
■  Bifurcated end holds soldered leads securely
■  T44: maximum 0.021” diameter leads or 24 gage wires
■  T68: maximum 0.032” diameter leads or 20 gage wires
■  260 Cartridge Brass

​​​T44, T68 Bifurcated miniwrap terminals for 0.042” diameter holes

​​​T49 Trifurcated Klipwrap terminals for 0.042" diameter holes

Tools sold separately

​​​TT125, T126  Wire Wrap Terminals for 0.042” diameter holes

​■  Wire-wrap tail with three-pronged receptacle for wires or leads
​■  0.025” square posts
​■  Wires or leads are crimped into receptacle on component side, secured for soldering
​■  Holds 0.018” - 0.025” diameter leads or 22 gage wires in lower slot,

     0.032” - 0.040” diameter leads or 17 gage wires in upper slot
​■  Overall length - 0.650”, 0.215” above 0.062” thick board with 0.373” below the board
​■  Phosphor Bronze

T46-4

Tools sold separately

T68, T68A

T125, T126

Tools sold separately

T44

​​​​​​​T46 Press-In terminals for 0.042” diameter holes

​■  Wire-Wrap terminal single and double-tailed (accessible from both sides) 

■   0.025” square posts
■   Provides secure contact without soldering or staking
■   Rectangular base with stepped shank presses into plain or plated-

       thru holes and is retained without etching or soldering
■   Pointed ends slide neatly into all wrapping bits
■   260 Cartridge Brass